The Multiplus-II 12/3000/120-32 is a high-end device combination of Victron Energy that combines classic multiplus components with an external current sensor and integrated anti-Icelanding function. This expands the functions PowerControl and Power Assist to 50 A. The inverter module provides a whopping 3000 W or 2400 W with a linear permanent burden on non -linear loads. The 12 V battery charger is also very well proportioned with 120 A charging power and is supplemented by a 32 A transfer switch, with which it can be switched back and forth between the AC connections.
Important performance features of the Multiplus-II 12/3000/120-32
PowerControl and Power Assist increase in network or generator performance
Built-in anti-Icelanding function and connection option for external electricity sensor (optional)
Can be used as a backup device in network -coupled systems for the power supply for network failures
can be used in different applications
Ideally suited for professional seafaring, yachts, vehicles and land -bound, native applications
Ve.Bus interface for parallel and three-phase operation, remote monitoring and system integration
Practically unlimited performance through parallel and three-phase operation
Can be configured on site or from a distance using Veconfigure software
technical features
3000 W power with non -linear load 2400 W continuous load and 5500 W Top performance
for 12 V battery voltage, 32 A transfer switch and 120 A battery charger
Output voltage: 230 VAC, frequency: 50 Hz
Max. Effect is 95%, protection class IP22
Always enough power thanks to PowerControl and Power Assist
A maximum network or generator current can be set on the Multiplus-II 12/3000/120-32. The Multiplus-II then takes into account other connected alternating current consumers and only uses the electricity to load the battery, which is still “left”. This prevents the generator or mains connection from being overloaded (PowerControl function). With the power assist function, the PowerControl principle receives a new dimension. Load tips often only occur for a limited period of time. In such a case, the multiplus-II compensates for the weak generator, land electricity or network output immediately by energy from the battery. The load is reduced, i.e. H. If consumers are switched off, the energy that is then sufficiently existing can be used again to charge the batteries.
Solar power: alternating current also in the event of a network failure
The device can be used for non-mesh-coupled and network-coupled PV systems as well as in other alternative energy systems. It can be used with solar charging regulators and with network-bound inverters.
Maximum flexibility thanks to two alternating current outputs
The main exit ensures uninterrupted operation. In the event of a network failure or in the event of an interruption of the land/generator current, the multiplus-II takes over the supply of the connected consumers. Switching happens so quickly (in less than 20 milliseconds) that an interruption -free operation of computers and other electronic devices is guaranteed. The second output only provides electricity if the Multiplus II AC. Consumers who are not allowed to unload the battery, such as B. a water heater can be connected to this output.
Many options for system expansion
The settings can be changed with the Veconfigure software within a few minutes (a computer or laptop and an MK3 USB interface are necessary). GX, Canvu GX, Laptop, Computer, Bluetooth (with the optional Ve.Bus Smart Dongle), battery guard, digital multi operating panel.
Configuration and monitoring remotely
Install a Color Control GX or other GX products to connect to the Internet. The operating data can be saved and viewed free of charge on our VRM (Victron Remote Management) website. If systems are connected to the Internet, you can access them from a distance and settings can be changed.
