The Victron Blue Smart IP65 Charger 12/15 (MPN: BPC121532034R) is a battery charger for rechargeable 12-V batteries. With a charging current of up to 15 A, it is suitable for lead-acid, AGM, gel, and LiFePO4 batteries. The 4 A low-current mode allows for adaptation to smaller battery capacities. The BPC121531034R model features a CEE 7/16 Euro plug and comes with interchangeable battery clamps and M8 ring terminals.
Smart Charging and Monitoring
Up to 15 A charging current for compatible 12-V batteries
4-A low-current mode for smaller battery capacities
Adaptive charging algorithms for lead-acid, AGM, gel, and LiFePO4 batteries
Bluetooth connectivity for configuration and monitoring via VictronConnect
IP65-rated enclosure and fanless convection cooling
Additional DC power supply mode
Protection features: reverse polarity, output short circuit, and overheating
Customized charging cycles for different battery types
For flooded lead-acid, AGM, and gel batteries, the charger uses an adaptive seven-stage charging algorithm. The duration of the constant-voltage phase is adjusted based on the previous charging history. The unit then switches to trickle charging and, if connected for an extended period, to storage mode with reduced voltage. A dedicated four-stage charging algorithm is available for LiFePO4 batteries. The selected charging mode must match the charging specifications and the capacity of the connected battery. Lithium batteries must not be charged when the battery temperature is below 0 °C.
Configuration and Monitoring with VictronConnect
The Blue Smart IP65 Charger can be connected to the VictronConnect app via the built-in Bluetooth interface. The app displays the current charge status, voltage, and charging current. Additionally, you can select charging profiles, adjust settings, view previous charging cycles, and perform firmware updates. The basic charging modes—Normal, High, and Lithium-Ion—can also be selected directly using the MODE button on the device. For compatible lead-acid batteries, a recovery phase intended only for occasional use can also be activated.
Trickle Charging, Power Supply, and Flexible Connections
Storage mode is intended for batteries that remain connected to the charger for an extended period. Via VictronConnect, the unit can also be configured as a DC power supply with a constant output voltage. The permanently attached DC cable features a replaceable connector for the included battery clamps or M8 ring terminals. Mounting brackets allow for permanent vertical installation. For permanent installations, a suitable overcurrent protection device must be installed as close to the battery as possible. The charger requires a ventilated location on a non-flammable surface and must not be operated directly above a battery or in an enclosed battery compartment.
Technical Specifications
Number of charging outputs: 1
Battery voltage: 12 V
Maximum charging current: 15 A
Charging current in low-current mode: 4 A
Lead-acid charging algorithm: 7-stage, adaptive
Lithium-ion charging algorithm: 4-stage
Mains frequency: 45–65 Hz
Power connection: CEE 7/16
Power cord length: 1.5 m
DC cable length: 1.5 m
DC cable cross-section: 4 mm² / 12 AWG
Maximum efficiency: 94%
Standby power: 0.5 W
Communication: Bluetooth via VictronConnect
Cooling: natural convection, fanless
Full rated power: up to 30 °C ambient temperature
Operating temperature: −40 to +50 °C
Protection rating: IP65
Weight: 0.9 kg
Dimensions: 60 × 105 × 190 mm
Package contents:
1x Victron Blue Smart IP65 Charger 12/15 with CEE-7/16 Euro plug
1x connection cable with battery terminals
1x connection cable with M8 ring terminals
1x User Manual
