The new Multiplus 12/800/35-16 from Victron Energy is the successor to the Multiplus Compact 12/800. This device is a modern device combination consisting of a powerful inverter with a pure sine wave, an advanced 50a battery loader that uses adaptive charging technology, and a 16A high-speed switch-voltage transfer switch.
In the event of a mains error or, if the country current or on -board generator is interrupted, the inverter of the Multiplus is automatically switched on and takes over the supply of the connected consumers. Switching happens so quickly (in less than 20 milliseconds) that an interruption -free operation of computers and other electronic devices is guaranteed.
most important features of the Multiplus 12/800/35-16
Account. at 25 ° C: 700W / 800W with non -linear load
For 12V system voltage
Integrated 35A network charger for your batteries
Integrated 16A network transfer switch
USV operation possible
Extensive accessories available
Can be used in numerous areas of application, whether on land or mobile
Proven reliability
The complete bridging with aRing transformeropology has proven itself for years. The inverter is short -circuit -resistant and protected against overheating (whether caused by overload or by the ambient temperature).
PowerControl - (Multiplus 800VA 1200VA)
With the remote control panel Multi Control, the maximum network or generator current can be set. The Multiplus then takes into account other connected alternating current consumers and only uses the electricity for charging, which is still “left”. This prevents the generator or land power connection from being overloaded.
Power assist - (Multiplus 800VA 1200VA)
Load tips often only occur for a limited period of time. In such a case, the Multiplus ensures that too weak land current or generator output is immediately compensated for by energy from the battery. The load is reduced, i.e. H. If consumers are switched off, the energy that is then sufficiently existing can be used again to charge the batteries.
High switch -on power
This is required to switch on loads with high insertion flows such as voltage formers for LED lamps, halogen lamps or power tools.
Search mode
If the search mode is up to 'on', the power consumption of the inverter is reduced by approximately 70% for zero-load operation. In this mode, the multi switches when it is operated in the inverter mode, at zero load or with only low loads and switches on again for a short period of time every two seconds. If the output current exceeds a set limit, the inverter resumes the operation. If this is not the case, the inverter switches off again.
Programmable multifunction relay
In the basic setting, the multifunction relay acts as an alarm relay.
