VICTRON Filax 2 Transfer CE 230V/50Hz-240V/60Hz

Stock: Small amount
Product number: SDFI0000000
EAN: 8719076025672

€309.00*

% €364.14* (15.14% saved)

€259.66*

% €364.14* (28.69% saved)

The ultra -fast Filax transfer switch from Victron Energy (MPN SDFI0000000) was developed to switch important or sensitive consumers such as computers, industrial control units or modern entertainment electronics from one change of alternating current to another. The main source is typically the power grid, a generator or a land connection. An inverter usually serves as an alternative source. With its switch -off time of less than 20 milliseconds, even sensitive loads continue to work without interruption.

The Filax is not designed to supply household appliances with high electricity consumption, such as washing machines or electric motors.

Gun switching function

The Filax is a transfer switch with a gun (non -bridge) switching function. The maximum time for switching the loads is 16 ms. The load is usually supplied with the main generator and is switched to the alternative source in the following cases:

  

  •  The voltage of the main power source falls below the threshold value.
  •  The frequency of the main power source falls below the low frequency threshold value or it exceeds the high frequency threshold value.

Switching back from the alternative power source to the main source of the main power as soon as the voltage and frequency values ​​of the main source of the main power are located for 30 seconds within the limit values ​​specified for switching back.

Technical specifications

  •  Max. Electricity: 16A
  •  Max. Time for switching: 16 ms
  •  Switching delay for switching back: 30 seconds
  •  Operating temperature range: -20 ° C - +50 ° C
  •  Moisture (not condensing): max. 95%
  •  Protection class: IP65
  •  Weight: 0.8 kg
  •  Dimensions: 120 x 255 x 75 mm

installation

  •  Install the Filax in a dry and well -ventilated environment.
  •  The input cables from the generator / main power supply and the output cables to the devices must be connected according to the circuit diagram.
  •  When connecting a load with less than 850 watts, the wire bridges must be removed.
  •  The frequency (50 Hz or 60 Hz) is set using a bridge. If the bridging is not set for the frequency, the switch-in threshold values ​​for the voltage are incorrect.
  •  Both inputs must be protected from electricity values ​​of over 16 amps.
  •  The front cover of the housing is attached using the four screws supplied.
  •  The Filax is now ready for use.

Scope of delivery:

1x Victron Energy Filax Transfer switch SDFI0000000
4x fastening screws
1x operating instructions

 

 

 

0 of 0 reviews

Leave a review!

Share your experiences with other customers.