Victron MultiPlus II 48/10000/140-100/100 230V

The Multiplus-II 48/10000/140-100 is a high-end device combination from Victron Energy (MPN PMP483105000) that combines classic Multiplus components with an external current sensor and integrated anti-islanding function. This extends the PowerControl and PowerAssist functions to 100A and expands the potential range of use to ESS applications. The inverter module delivers a whopping 10,000 W with a non-linear load, or 8,000 W with a continuous linear load. The 48 V battery charger is also very well proportioned with 140 A charging capacity and is supplemented by a 100 A transfer switch, which can be used to switch back and forth between the AC connections at lightning speed.

Important features of the Multiplus-II 48/10000/140-100

• PowerControl and PowerAssist - Increase in grid or generator power
• built-in anti-islanding function and connection option for external current sensor (optional)
• can be used as a backup device in grid-connected systems for power supply in the event of grid failures
• can be used in various ESS (Energy Storage System) applications
• best suited for professional seafaring, yachts, vehicles and land-based, off-grid applications
• VE.Bus interface for parallel and three-phase operation, remote monitoring and system integration
• Practically unlimited power through parallel and three-phase operation
• can be configured locally or remotely using VEConfigure software*

Technical features

• 10000 W power at non-linear load 8000 W continuous load and 18000 W peak power
• for 48V battery voltage, 100A transfer switch and 140A battery charger
• Output voltage: 230 VAC, frequency: 50 Hz
• max. Efficiency is 95%, protection class IP22

A maximum mains or generator current can be set on the Multiplus-II 48/10000/140-100. The MultiPlus-II then takes into account other connected AC consumers and only uses the current that is "left" to charge the battery. This prevents the generator or mains connection from being overloaded (PowerControl function). With the function PowerAssist gives the PowerControl principle a new dimension. Peak loads often only occur for a limited period. In such a case, the MultiPlus-II compensates for insufficient generator, shore power or mains power immediately with energy from the battery. The load is reduced , i.e. if consumers are switched off, the sufficient energy that is then available can be used to charge the batteries.

The device can be used with off-grid and grid-connected PV systems as well as with other alternative energy systems. It can be used with both solar charge controllers and grid-tied inverters.

The main exit ensures uninterrupted operation. In the event of a power failure or an interruption in the shore/generator power, the MultiPlus-II takes over the supply of the connected consumers. The switchover happens so quickly (less than 20 milliseconds) that computers and other electronic devices can continue to operate without interruption. The second output provides power only when AC power is available at the input of the MultiPlus-II. Consumers who are not allowed to discharge the battery, e.g. B.a water heater, can be connected to this output

Settings can be changed in minutes using VEConfigure software (requires a computer or laptop and MK3 USB interface). Several monitoring and control options are available: Color Control GX, Venus GX, Octo GX, CANvu GX, Laptop, Computer, Bluetooth (with optional VE.Bus Smart Dongle), Battery Monitor, Digital Multi Control Panel.

Install a Color Control GX or other GX products to connect to the Internet. The operating data can be stored and viewed free of charge on our VRM (Victron Remote Management) website. When systems are connected to the internet, they can be accessed remotely and settings can be changed.

1x Victron PMP483105000 Multiplus-II 48/10000/140-100A

1x operating instructions

data sheet